ARTIK USB and microSD Connectors
ARTIK USB Interfaces
Descriptions of USB interface usage are categorized as follows.
- Accessing USB storage devices (ARTIK 530, 710, and 1020)
- Acting as USB peripheral device (ARTIK 520, 530, 710, and 1020)
- Acting as USB host controller (ARTIK 530, 710, and 1020)
The USB interfaces typically available for end-user use are shown below. Debug USB interface locations (for terminal emulator connection) can be found here.
The ARTIK 020/030 module itself does not include USB. The base board provides (for updating firmware): - One USB 2.0 port - Device mode only - Mini type B receptacle |
 |
The ARTIK 05X module itself does not include USB. The base board provides (for updating firmware): - One USB port, dual function - Device mode only, COM + JTAG - Micro-AB receptacle |
 |
The ARTIK 520 module provides: - One USB 2.0 port - Device mode only - Mini type B receptacle |
 |
The ARTIK 530 and 710 modules provide: - One USB 2.0 OTG port - Host controller/device mode, selected by OTG protcols - Micro-AB receptacle Through USB hub on board: - Two USB 2.0 ports - Host Controller mode only - Stacked type A receptacle |
 |
The ARTIK 1020 module provides: - One USB 3.0 port - Host controller/device mode, dynamically selected - Standard type A receptacle Through USB/Ethernet port expander on board: - Two USB 2.0 ports - Host Controller mode only - Stacked type A receptacle |
 |
ARTIK microSD Interface
The ARTIK 520, 530, 710, and 1020 development boards each provide a microSD card interface. The microSD card can be used for:
- General purpose storage
- Upgrade of the system firmware image.
The ARTIK 0 image can be updated only through a serial link.
Last updated on: